About nozzles splicing in the G10+ Series Online Inkjet Printers

To achieve greater print height, the nozzles must be spliced. The splicing method for the G10+ involves just three simple steps:

I.   The three-step adjustment method is as follows:

Step 1:  Set all nozzles parameters to 0, disable all switch options, and print directly to observe the output.

Set the reference nozzle to the one that printed information last (only Nozzle 1 or 4, delay = 0).

Step 2:  Test each of the four switch combinations in sequence to determine the correct setting.

Combination 1: Enable only horizontal switch;

Combination 2: Enable only vertical switch;

Combination 3: Enable all switch directions (horizontal and vertical);

Combination 4: Disable all switch directions.

Step 3:  Then adjust the other three nozzles in sequence (The three nozzles other than the reference nozzle).

Use 27 as the standard splicing delay and fine-tune as needed for proper alignment.

Why use 27 as the standard splicing delay?

Due to physical limitations, there is a physical spacing of 27.1mm between the nozzles.

When set all nozzle parameters to 0, disable all switch options, and print directly to observe the output.

At this moment nozzle 1 is the reference nozzle. (Step 1)

After the nozzles splicing is completed. (Specific values will be adjusted based on actual circumstances.)

II.   Video demo: